<< LOCK-N-STITCH® Products << Countersinks and Spotfacers
A spotfacer is required for C Series pins. Spotfacers cut a recess into the surface of the casting to accept part of the shoulder of the C Series stitching pins. Some of the shoulder must remain below the surface after it is ground or machined flat. The shoulder is what holds the SpiralhookTM threads tight. Spotfacers cut an angle into the surface that matches the negative angle under the shoulder of the corresponding pin. This creates additional holding power. Approximately 50% of the shoulder should be below the surface whenever possible. However, in very thin material keep the spotface shallow to leave as much room for threads as possible. Approximately 0.020" should serve as a minimum for spotface depth. If an invisible repair is not an issue, you can leave approximately 50% of the shoulder protruding above the surface of the completed repair for additional strength. Use a slow speed drill with all spotfacers
Spotfacers for C1 Stitching Pins
Spotfacers for C2F Stitching Pins
Spotfacers for C3 Stitching Pins
Spotfacers for C4 Stitching Pins
It’s not a crack free world..... |
