|
LOCKS PRODUCTS
The L10 lock is our narrowest lock. With a major width of only 0.204", it can fit into some pretty tight spots. It comes in two thicknesses: L10B, for stacking into a deep hole pattern and L10S, for installation at the surface. When installing locks on a machined surface, leave a small portion (approx 0.040") above the surface to peen and machine down. Use this lock in material ranging from 1/8" to 3/8" in thickness.
The L15/5 lock is a 5-lobe lock. This design allows for the maximum tensile strength in the shortest distance. L15/5 was designed for fast installation with a primary use in repairing automotive and diesel engine blocks. With an overall length of only 0.793" it can be installed across cracks that run close to and parallel to an edge or obstacle. Use this lock in material ranging from 3/16" to 7/16" in thickness.
This lock transfers the grip on the cast iron farther away from the crack than does the L15/5 lock. Use in repairing castings ranging in thickness from 1/4" to 1/2". The most frequent applications for the L15 lock are repairing cracks in automotive, construction, farming, and trucking castings. Remember to stack the locks to a depth of approximately 80% of the casting thickness.
The L20 lock offers a considerable amount of strength for its size. Drilling the hole pattern is fast and easy. Because of its short length, it is very easy to locate installation sites on the casting. While it is often placed in larger castings in the automotive industry, it has many applications in industrial use. Use this lock in castings with a wall thickness of 0.375" to 0.750".
The L30 lock is used mostly for industrial repairs. With an overall length of 2.818" and a maximum width of 0.609" it is large enough to be considered an industrial application. This size is intended for casting thicknesses of 3/8" to 1". A drill pilot bushing comes with the kit to make drilling easier. It allows you to pilot drill all of the holes to 3/16" prior to drilling the larger holes of the pattern.
The L40 lock has an overall length of 3.770" and a maximum width of 0.820". It is used in castings with wall thicknesses ranging from 1" to 3". The hole pattern for this lock can be drilled with a hand-held drill. A drill bushing is provided to allow pilot drilling of all holes to make drilling of the 1/2" diameter holes easier. Because of the aggressive design of LNS locks these L40 locks hold up
The L50 lock offers a very high strength capability. Stack one on top of another into hole patterns up to four inches deep. Uses include large punch presses, crusher frames, steam turbines
The L60 lock is our largest lock. It is capable of creating an incredibly strong mechanical repair. The hole pattern for this lock can most easily be drilled with a magnetic base drill press. Install in castings up to seven inches thick by stacking one on top of another.
It’s not a crack free world..... |
